</a>環境噪音消除" title="環境噪音消除">環境噪音消除" title="環境噪音消除">環境噪音消除（ANC）功能的揚聲器放大器，能降低本底環境噪音，從而提高了手持設備，耳機，語音通信設備等的音頻質量。ANC處理的帶寬10-2000Hz，噪音降低10-30dB，主要用于耳機，手持設備，手機，免提卡和語音通信設備。本文介紹了AS3400/10/30主要特性，反饋和正饋方框圖，反饋應用案例電路圖與差分正饋應用案例電路圖。
The AS3400/10/30 are speaker driver with Ambient Noise Cancelling function for handsets, headphones or ear pieces. It is intended to improve quality of e.g. music listening, a phone conversation etc. by reducing background ambient noise.
The fully analog implementation allows the lowest power consumption, lowest system BOM cost and most natural received voice enhancement otherwise difficult to achieve with DSP implementations. The device is designed to be easily applied to existing architectures.
An internal OTP-ROM can be optionally used to store the microphones gain calibration settings.
The AS3400/10/30 can be used in different configurations for best trade-off of noise cancellation, required filtering functions and mechanical designs.
The simpler feed-forward topology is used to effectively reduce low frequency background noise. The feed-back topology with either 1 or 2 filtering stages can be used to reduce noise for a larger frequency range, and to even implement transfer functions like speaker equalization, Baxandall equalization, high/low shelving filter and to set a predefined loop bandwidth.
The filter loop is optimized by the user for specific handset electrical and mechanical designs by dimensioning simple R, C components. Most handset implementations will make use of a single noise detecting microphone. Two microphones could be used to allow for increased flexibility of their location in the handset mechanical design. Using the bridged mode allows to even drive high impedance headsets.
AS3400/10/30主要特性：
Microphone Input
?? 128 gain steps @ 0.375dB and MUTE with AGC
?? Differential, low noise microphone amplifier
?? Single ended or differential mode
?? Improved supply for electret microphone
?? MIC gain OTP programmable
High Efficiency Headphone Amplifier
?? 2x34mW, 0.1% THD @ 16Ω, 1.5V supply,
100dB SNR
?? Bridged mode for e.g. 300Ω loads
?? Click and pop less start-up and mode switching
Line Input
?? Volume control via serial interface or volume pin
?? 64 steps @ 0.75dB and MUTE, pop-free gain setting
?? Single ended stereo or mono differential mode
ANC processing
?? Feed-forward cancellation
?? Feed-back cancellation with filter loop transfer function definable via simple RC components
?? Simple in production SW calibration
?? 12-30dB noise reduction (headset dependent)
?? 10-2000Hz wide frequency active noise attenuation (headset dependent)
Monitor Function
?? For assisted hearing, i.e. to monitor announcements
?? Fixed (OTP prog.) ambient sound amplification to compensate headphone passive attenuation
?? Volume controlled ambient sound amplification mixed with fixed (OTP prog.) attenuation of LineIn
Incremental Functions
?? ANC with or without music on the receiving path
?? Improved dynamic range playback
?? OTP ROM for automatic trimming during production (4 times programbable)
Performance Parameter
?? 5/3.8mA @ 1.5V stereo/mono ANC; <1μA quiescent
?? Extended PSRR for 217Hz
Interfaces
?? 2-wire serial control mode & volume inputs
?? Calibration via Line-In or 2-wire serial interface (patent pending)
?? Single cell or fixed 1.0-1.8V supply with internal CP
Package
?? AS3400, AS3410 QFN24 [4x4mm] 0.5mm pitch
?? AS3430 QFN32 [5.x5mm] 0.5mm pitch
AS3400/10/30應用：
The devices are ideal for Ear pieces, Headsets, Hands-Free Kits, Mobile Phones, and Voice Communicating Devices.
圖1。AS3400反饋方框圖
圖2。AS3400前饋方框圖
圖3。AS3400前饋ANC方框圖
圖4。AS3430反饋應用案例電路圖
圖5。AS3430差分正饋應用案例電路圖
詳情請見：
http://www.austriamicrosystems.com/content/download/143123/756655/85634
The AS3400/10/30 are speaker driver with Ambient Noise Cancelling function for handsets, headphones or ear pieces. It is intended to improve quality of e.g. music listening, a phone conversation etc. by reducing background ambient noise.
The fully analog implementation allows the lowest power consumption, lowest system BOM cost and most natural received voice enhancement otherwise difficult to achieve with DSP implementations. The device is designed to be easily applied to existing architectures.
An internal OTP-ROM can be optionally used to store the microphones gain calibration settings.
The AS3400/10/30 can be used in different configurations for best trade-off of noise cancellation, required filtering functions and mechanical designs.
The simpler feed-forward topology is used to effectively reduce low frequency background noise. The feed-back topology with either 1 or 2 filtering stages can be used to reduce noise for a larger frequency range, and to even implement transfer functions like speaker equalization, Baxandall equalization, high/low shelving filter and to set a predefined loop bandwidth.
The filter loop is optimized by the user for specific handset electrical and mechanical designs by dimensioning simple R, C components. Most handset implementations will make use of a single noise detecting microphone. Two microphones could be used to allow for increased flexibility of their location in the handset mechanical design. Using the bridged mode allows to even drive high impedance headsets.
AS3400/10/30主要特性：
Microphone Input
?? 128 gain steps @ 0.375dB and MUTE with AGC
?? Differential, low noise microphone amplifier
?? Single ended or differential mode
?? Improved supply for electret microphone
?? MIC gain OTP programmable
High Efficiency Headphone Amplifier
?? 2x34mW, 0.1% THD @ 16Ω, 1.5V supply,
100dB SNR
?? Bridged mode for e.g. 300Ω loads
?? Click and pop less start-up and mode switching
Line Input
?? Volume control via serial interface or volume pin
?? 64 steps @ 0.75dB and MUTE, pop-free gain setting
?? Single ended stereo or mono differential mode
ANC processing
?? Feed-forward cancellation
?? Feed-back cancellation with filter loop transfer function definable via simple RC components
?? Simple in production SW calibration
?? 12-30dB noise reduction (headset dependent)
?? 10-2000Hz wide frequency active noise attenuation (headset dependent)
Monitor Function
?? For assisted hearing, i.e. to monitor announcements
?? Fixed (OTP prog.) ambient sound amplification to compensate headphone passive attenuation
?? Volume controlled ambient sound amplification mixed with fixed (OTP prog.) attenuation of LineIn
Incremental Functions
?? ANC with or without music on the receiving path
?? Improved dynamic range playback
?? OTP ROM for automatic trimming during production (4 times programbable)
Performance Parameter
?? 5/3.8mA @ 1.5V stereo/mono ANC; <1μA quiescent
?? Extended PSRR for 217Hz
Interfaces
?? 2-wire serial control mode & volume inputs
?? Calibration via Line-In or 2-wire serial interface (patent pending)
?? Single cell or fixed 1.0-1.8V supply with internal CP
Package
?? AS3400, AS3410 QFN24 [4x4mm] 0.5mm pitch
?? AS3430 QFN32 [5.x5mm] 0.5mm pitch
AS3400/10/30應用：
The devices are ideal for Ear pieces, Headsets, Hands-Free Kits, Mobile Phones, and Voice Communicating Devices.
圖1。AS3400反饋方框圖
圖2。AS3400前饋方框圖
圖3。AS3400前饋ANC方框圖
圖4。AS3430反饋應用案例電路圖
圖5。AS3430差分正饋應用案例電路圖
詳情請見：
http://www.austriamicrosystems.com/content/download/143123/756655/85634
本站內容除特別聲明的原創文章之外，轉載內容只為傳遞更多信息，并不代表本網站贊同其觀點。轉載的所有的文章、圖片、音/視頻文件等資料的版權歸版權所有權人所有。本站采用的非本站原創文章及圖片等內容無法一一聯系確認版權者。如涉及作品內容、版權和其它問題，請及時通過電子郵件或電話通知我們，以便迅速采取適當措施，避免給雙方造成不必要的經濟損失。聯系電話：010-82306118；郵箱：aet@chinaaet.com。