《電子技術應用》
您所在的位置:首頁 > 微波|射頻 > 設計應用 > 帶電介質板對電磁波的衰減特性研究
帶電介質板對電磁波的衰減特性研究
2022年電子技術應用第1期
張 超,孔曉玉,鄭丹丹
河北太行計量檢測有限公司,河北 石家莊050000
摘要: 電磁信號在穿透帶電介質板時由于電磁波的散射等原因其信號強度會降低,甚至會改變電磁波的極性。為了測量電荷本身對電磁波衰減的影響,設計了帶電介質板對電磁波的衰減實驗,選取了PP板、PVC板、PMMA板等典型介質板,對電磁波信號衰減進行了實驗研究。研究結果表明介質板帶電會增強對電磁波的衰減,且隨著電量增加,衰減增強。
中圖分類號: TN011;O241.4;O441.4
文獻標識碼: A
DOI:10.16157/j.issn.0258-7998.211864
中文引用格式: 張超,孔曉玉,鄭丹丹. 帶電介質板對電磁波的衰減特性研究[J].電子技術應用,2022,48(1):152-156.
英文引用格式: Zhang Chao,Kong Xiaoyu,Zheng Dandan. Study on the scattering characteristics of electromagnetic wave with dielectric band[J]. Application of Electronic Technique,2022,48(1):152-156.
Study on the scattering characteristics of electromagnetic wave with dielectric band
Zhang Chao,Kong Xiaoyu,Zheng Dandan
Hebei Taihang Measurement Co.,Ltd.,Shijiazhuang 050000,China
Abstract: When the electromagnetic signal penetrates the medium, its signal intensity will be reduced due to the scattering of electromagnetic waves and other reasons, and even change the polarity of electromagnetic waves. In order to measure the influence of electric charge on electromagnetic wave attenuation, this paper designed an electromagnetic wave attenuation experiment with dielectric plate, and selected typical dielectric plates such as PP plate, PVC plate and PMMA plate to conduct an experimental study on electromagnetic wave signal attenuation. The results show that the attenuation of electromagnetic wave is enhanced when the dielectric plate is charged, and the attenuation is enhanced with the increase of electric quantity.
Key words : electromagnetic wave;charged quantity;attenuation;dielectric plate

0 引言

    電介質,又叫作絕緣體,它們中的電子被束縛在它所屬的原子核周圍,因而在物質內部的自由電子極少,即使受到外電場的作用,其分子中的絕大多數帶電粒子也只能作微觀位移,不可能像導體中的自由電子那樣發生宏觀遷移[1]。

    電導率是表示物質傳輸電流能力強弱的一種測量值,以歐姆定律定義為電流密度和電場強度的比率。相對介電常數表征材料的介電性質或極化性質的物理參數,其值等于預測材料為介質與以真空介質制成的同尺寸電容器電容量之比[2-4]。介電常數與電導率之間的關系是εe=ε(1-jk/ωε)。其中,εe為介電常數,k為介質的電導率,ω為電磁波的角頻率,ε著為理想介質的介電常數。由此推導出,當εe=ε時,電導率為0,面電導率為0。帶電量為0時電導率為0,帶電量不為0時電導率不為0。

    物質的導電性不僅與其凝聚狀態和組成結構有關,而且與物質所處的外電場條件有關,物質在傳導靜電過程中,導電性是由物質與電場共同確定的。處在強場中的物質,分子電偶極矩的大小、分子的排列分布狀態、結晶點陣的熱振動情況等都可能發生較大的變化,從而改變物質的導電性能[5]。




本文詳細內容請下載:http://ihrv.cn/resource/share/2000003928




作者信息:

張  超,孔曉玉,鄭丹丹

(河北太行計量檢測有限公司,河北 石家莊050000)




wd.jpg

此內容為AET網站原創,未經授權禁止轉載。