《電子技術應用》
您所在的位置:首頁 > 模擬設計 > 解決方案 > AllegromicroA4933三相馬達控制方案

AllegromicroA4933三相馬達控制方案

2011-08-25
作者:Allegromicro公司
關鍵詞: 接口IC Allegromicro公司

Allegromicro公司的A4933是和外接功率MOSFET一起使用的三相馬達控制器.當電池電壓低于7V時集成的電荷泵提供大于10V的柵極驅動.器件的電源電壓5.5V-50V,并和3.3V與5V邏輯電平兼容.本文介紹了A4933主要特性和優勢,方框圖,典型應用電路以及電流檢測放大器配置圖.

The A4933 is a 3-phase controller for use with N-channel external power MOSFETs and is specifically designed for automotive applications.

A unique charge pump regulator provides full (>10 V) gate drive for battery voltages down to 7 V and allows the A4933 to operate with a reduced gate drive, down to 5.5 V. A bootstrap capacitor is used to provide the above-battery supply voltage required for N-channel MOSFETs. An internal charge pump for the high-side drive allows DC (100% duty cycle) operation.

Full control over all six power FETs in the 3-phase bridge is provided, allowing motors to be driven with block commutation or sinusoidal excitation. The power FETs are protected from shoot-through by integrated crossover control and resistor adjustable dead time.

Bridge current can be measured using an integrated current sense amplifier. This is an uncommitted differential amplifier with a below-ground common mode range allowing it to be used in low-side current sense applications. Gain and offset are defined by external resistors. Integrated diagnostics provide indication of undervoltage, overtemperature, and power bridge faults. They can be configured to protect the power FETs under most short circuit conditions.

Detailed diagnostics are available as a serial data word. The A4933 is supplied in a 48-pin LQFP with exposed thermal pad, (suffix JP). This is a small footprint (81 mm2) power package. It is lead (Pb) free with 100% matte tin leadframe plating.

A4933主要特性和優勢:

? High current 3-phase gate drive for large N-channel MOSFETs

? Pin compatible with Allegro® A4935KJP

? Cross-conduction protection with adjustable dead time

? Top-off charge pump for 100% PWM

? Charge pump for low supply voltage operation

? Uncommitted current sense amplifier

? 5.5 to 50 V supply voltage range

? Compatible with 3.3 V and 5 V logic

? Extensive diagnostic outputs

? Low-current sleep mode

圖1. A4933方框圖

圖2. A4933建議電源路徑圖

圖3. A4933典型應用電路圖

圖4. A4933電流檢測放大器配置圖
詳情請見:
http://www.allegromicro.com/en/Products/Part_Numbers/4933/4933.pdf



本站內容除特別聲明的原創文章之外,轉載內容只為傳遞更多信息,并不代表本網站贊同其觀點。轉載的所有的文章、圖片、音/視頻文件等資料的版權歸版權所有權人所有。本站采用的非本站原創文章及圖片等內容無法一一聯系確認版權者。如涉及作品內容、版權和其它問題,請及時通過電子郵件或電話通知我們,以便迅速采取適當措施,避免給雙方造成不必要的經濟損失。聯系電話:010-82306118;郵箱:aet@chinaaet.com。