《電子技術應用》
您所在的位置:首頁 > 电源技术 > 设计应用 > OLED电源解决方案
OLED电源解决方案
摘要: TI 公司的TPS65137 是有源矩阵 OLED (AMOLED)电源解决方案,包括一个采用LDO作为后稳压器的升压转换器,输入电压从2.3V到5.5V,具有极好的线瞬态稳压功能,输出电压精度1%,低噪音,输出电流200mA,固定4.6V正输出电压,数字可编程负输出电压可低至-5.2V,具有短路保护和热关断,主要用在有源矩阵 OLED(AMOLED)。本文介绍了TPS65137主要特性,方框图以及典型应用电路。
Abstract:
Key words :

TI 公司的TPS65137 是有源矩陣 OLEDAMOLED)電源解決方案,包括一個采用LDO作為后穩壓器的升壓轉換器,輸入電壓從2.3V到5.5V,具有極好的線瞬態穩壓功能,輸出電壓精度1%,低噪音,輸出電流200mA,固定4.6V正輸出電壓,數字可編程負輸出電壓可低至-5.2V,具有短路保護和熱關斷,主要用在有源矩陣 OLED(AMOLED)。本文介紹了TPS65137主要特性,方框圖以及典型應用電路。

The TPS65137 consists of a boost converter using a LDO as post regulator. The output voltage of the boost converter is regulated to operate the internal LDO above its dropout voltage maintaining best line and load regulation of OUTP. The internal LDO disconnects OUTP during shutdown and allows regulation of the output when the input voltage is higher than OUTP. The LDO minimizes the output voltage ripple of OUTP. The negative output uses a buck boost converter topology operating in DCM (Discontinuous Conduction Mode) providing superior line regulation. In order to adjust the output voltage of the negative converter a digital interface can be used to program the output voltage. To achieve high efficiency over the entire load current range the device reduces the switching frequency with the load current using its internal voltage controlled oscillator (VCO). Since the boost converter output CB is post regulated by the integrated LDO (Low Dropout Regulator) the output voltage ripple is minimized and the line transient response is at its best. Because of this topology the operation mode of the boost converter has minimum effect on the output voltage ripple observed on OUTP. The boost converter, as well as the negative converter operate in peak current mode using the VCO (Voltage Controlled Oscillator) while operating in DCM (Discontinuous Conduction Mode). When entering CCM (Continuous Conduction Mode) the converter operates in peak current control using fixed off time control.

TPS65137主要特性:

2.3 V to 5.5 V Input Voltage Range

1% Output Voltage Accuracy Vpos

Excellent Line Transient Regulation

Low Noise Operation

200 mA Output Current

Fixed 4.6 V Positive Output Voltage

Digitally Programmable Negative Output Voltage Down to –5.2V

–4.9V Default Value for Vneg

Advanced Power Save Mode

Short Circuit Protection

Thermal Shutdown

TPS65137A High impedance output in shutdown

3×3 mm 10 Pin QFN Package

TPS65137應用:

Active Matrix OLED Power Supply


圖1。TPS65137功能方框圖

圖2。TPS65137典型應用電路圖
詳情請見:
http://focus.ti.com/lit/ds/symlink/tps65137.pdf

此內容為AET網站原創,未經授權禁止轉載。